Fresh Recalls

⚠ Data freshness notice: the most recent refresh of CPSC was incomplete, so a very recent recall may be missing. Everything shown is accurate as of the last checked time on this page — for anything time-critical, confirm with the official sources linked below.

Altec Industries recalls

8 recent recalls on record for Altec Industries in connected official government data as of August 29, 2026 at 6:12 PM UTC.

All Altec Industries recalls

NHTSA · Vehicle · August 21, 2026

Altec Industries Forward Collision Avoidance recall (26V541000)

An improperly calibrated system may have a delayed braking response, increasing the risk of a crash.

Official ID 26V541000 · Official record ↗

NHTSA · Vehicle · July 17, 2026

Altec At Series recall (26V463000)

A fastener that has not been heat treated could fail, resulting in separation of the pedestal and turntable, increasing the risk of injury.

Official ID 26V463000 · Official record ↗

NHTSA · Vehicle · July 16, 2026

Altec AP Series recall (26V457000)

An overheated wire can ignite flammable material in the cargo area, increasing the risk of fire.

Official ID 26V457000 · Official record ↗

NHTSA · Vehicle · July 2, 2026

Altec Service Body recall (26V429000)

A short may cause the inverter AC wiring to overheat, increasing the risk of a fire.

Official ID 26V429000 · Official record ↗

NHTSA · Vehicle · June 26, 2026

Altec Digger Derrick recall (26V409000)

While using the pole rack at full capacity, an incorrect high vertical center of gravity during braking and cornering may lead to a loss of vehicle control, increasing the risk of …

Official ID 26V409000 · Official record ↗

NHTSA · Vehicle · June 12, 2026

Altec At Series recall (26V386000)

An aerial device that operates while the vehicle is in gear or neutral can cause unexpected vehicle movement and increase the risk of injury.

Official ID 26V386000 · Official record ↗

NHTSA · Vehicle · June 11, 2026

Altec AC Series Crane recall (26V384000)

Missing welds can lead to platform joint failure due to fatigue or overload, resulting in the platform falling from the boom tip, increasing the risk of injury.

Official ID 26V384000 · Official record ↗

NHTSA · Vehicle · May 15, 2026

Altec Industries Equipment recall (26V310000)

Hydraulic functions that do not immediately stop when the ground level E-stop is pressed, increase the risk of injury.

Official ID 26V310000 · Official record ↗

Verify with the official sources:

Found something wrong or missing? Report a data error.

Compiled from official public-domain government data. Last checked August 29, 2026 at 6:12 PM UTC.